TENSIONER PULLEY VRIBBED BELT FOR HYUNDAI SONATA/VI/VII SONICA EMBERA NF i45 HERTH+BUSS JAKOPARTS J1140358

The efficient operation of an automobile generator as a source of energy for various devices is feasible under the condition of normal belt tension. Almost all modern cars are equipped with a specific device called the HERTH+BUSS JAKOPARTS brand Tensioner Pulley, v-ribbed belt. It regulates the tension force of the belt drive.

The tension roller of the v-ribbed belt has a rather simple mechanism; its most important component is the bearing.

1. SONATA V (NF)
2. SONATA V Saloon (NF)
3. SONICA V (NF)
4. EMBERA V (NF)
5. NF V (NF)
6. SANTA FE II (CM)
7. SONATA VI (YF)
8. i45 VI Saloon (YF)
9. i45 VI (YF)
10. MAGENTIS (MG)
11. MAGENTIS Saloon (MG)
12. OPTIMA (MG)
13. LOTZE (MG)
14. LOTZE / OPTIMA (MG)
15. CARENS III MPV (UN)
16. RONDO III MPV (UN)
17. OPTIMA
18. OPTIMA (TF)
19. K5
20. ix35 (LM, EL, ELH)
21. See more in applications

The principle of the tensioner pulley work

It is necessary not only to control the degree of belt tension, but also to periodically check the performance of this element. This approach will extend the performance of the entire system.

In the event that the belt is too loose, it will begin to slip, which will cause noise, a sharp rise in temperature and premature wear. Any of these causes can result in poor performance of belt-driven accessories. If the belt tension is too high, severe wear of the belt-driven accessories can be expected.