Tie Rod End - CEKK-4 CTR

The steering rods connect the steering gear and the wheel, it is through them that the driver transfers the steering force from the steering gear to the wheels. The CTR brand Tie Rod End is attached to the steering rack rod by means of an inner end, to the middle rod of the trapezium - by means of a swivel joint. The rods are connected to the steering knuckle through an external tie rod end.

Internal tie rod ends and ball joints provide vertical mobility of the link - otherwise the links would break off when the vehicle is driven over uneven surfaces. The outer tie rod end provides mobility of the rod and wheel in any plane - so the drive can work normally on turns, pits without damage.

1. E Van (SR2)
2. BONGO Van (SR2)
3. E Bus (SR1)
4. BONGO Bus (SR1)
5. BONGO BRAWNY Bus (SR1)
6. MARATHON Bus (SR1)
7. E Platform/Chassis (SD1)
8. BESTA Van
9. K2500 (SD)
10. K2500 Platform/Chassis (SD)
11. FRONTIER (SD)
12. BONGO III (SD)
13. K2700 (SD)
14. K2700 Platform/Chassis (SD)
15. BONGO Platform/Chassis
16. BONGO / K-SERIES Platform/Chassis
17. BONGO III Platform/Chassis
18. K-SERIES Platform/Chassis
19. K2700
20. K4000G
21. See more in applications

The construction of the tie rod end

As for the device, the rod itself resembles a steel bar. The device of the tie rod end is more complicated, since it serves to connect movable and fixed elements. In fact, it is a swivel joint where the sphere of the pin rotates inside a hemispherical body. A bushing is installed in the body, grease is packed to avoid friction and to allow the pin to deflect at a predetermined angle. The hinge protects the rubber boot.