The SWAG brand Brake Drum is a key element of the drum brake system, which is influenced by drum-type brake pads during braking. The friction of the brake pads on the brake drum will cause the vehicle to stop.

As a rule, brake drums are made from special grades of cast iron. The principle of operation of the drum brake system differs from the disc type - if in the disc assembly the pads compress the disc to stop the car, then in the drum, the pads, on the contrary, are unclenched, pressing on the inner walls of the drum.

1. BOXER Bus (230P)
2. DUCATO Bus (230_)
3. JUMPER Bus (230P)
4. RELAY Bus (230P)
5. DUCATO Van (230_)
6. BOXER Van (230L)
7. BOXER FURGON Van (230L)
8. JUMPER Van (230L)
9. RELAY Van (230L)
10. JUMPER Platform/Chassis (230)
11. RELAY Platform/Chassis (230)
12. BOXER Platform/Chassis (ZCT_)
13. DUCATO Platform/Chassis (230_)
14. BOXER Bus (244, Z_)
15. JUMPER Bus (244, Z_)
16. RELAY Bus (244, Z_)
17. BOXER Platform/Chassis (244)
18. BOXER Van (244)
19. JUMPER Van (244)
20. RELAY Van (244)
21. See more in applications

The functionality of the brake drums

The efficiency of drum brakes is much lower than disc brakes, at the same time, drum-type braking systems are still used on the rear axles of cars. The reason for this may be a greater reliability of the assembly than a similar disk-type assembly, since the pads are protected from the external environment, such as water or dirt. So, as a result of water entering the disc brake system, with insufficient driving experience, loss of control is possible due to the short-term ineffectiveness of disc brakes without additional "drying" (short braking) before the main braking. The drum braking system does not require such handling, and with less efficiency it leaves more chances for braking in the absence of additional skills.