The anti-roll bar consists of an elastic bracket and two struts or rods. The struts are one of the elements that bond the body and suspension together. They help to improve vehicle dynamics and safety.

The sway bar is a conventional rod with pivot joints welded along the edges. These connections include a yoke and a pivot pin and are threaded at the ends to attach the struts to other suspension components. To protect the linkage components from premature wear due to the ingress of dust and dirt, the articulated joints are closed with anthers from above.

1. DUCATO Van (250_, 290_)
2. DUCATO Bus (250_, 290_)
3. DUCATO Bus (250_, 290_, 560_)
4. DUCATO Platform/Chassis (250_, 290_)
5. BOXER Bus
6. MANAGER Bus
7. BOXER Van
8. MANAGER Van
9. BOXER Platform/Chassis
10. MANAGER Platform/Chassis
11. JUMPER Bus
12. RELAY Bus
13. JUMPER Van
14. RELAY Van
15. JUMPER Platform/Chassis
16. RELAY Platform/Chassis
17. See more in applications

The work of the suspension sway bar

Based on the design features, a distinction is made between symmetrical or asymmetrical sway bars. Only the front bars can be symmetrical, they can be swapped and turned over, asymmetrical are installed only on a certain - the right or left side of the suspension.

The SIDEM brand Sway Bar, suspension is the most vulnerable part of the stabilizer. Its service life is no more than 20 thousand kilometers, but sometimes they break down much earlier. You can find out about the malfunction by the characteristic knock that occurs when you hit an obstacle. In some cases, the car starts to get out of the roll hard. If crunching sounds occur when the steering wheel is turned, then the boot is most likely torn.